Posted by vt joe on July 20, 2010 at 05:06:33 from (216.114.161.59):
In Reply to: Super Major 5000 posted by vt joe on July 18, 2010 at 13:06:36:
The problem on the fuel line was that the Ferrel had not been installed correctly so many years ago as the pipe needs to extend beyond the ferrel just a little bit as with most other compression fittings. It had come loose before and i soldered it back on as pipe would not got thru as it should. when engine over revved, fuel pressure went up to the point that soft solder could not hold it anymore. So this time i filed the hole enough to let pipe pass thru slightly and brazed it on. I know this is short term fix but I couldn"t wait to get new fuel lines from agriline. On another note. just what is correct procedure for looking at the govenor on a Simms pump?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.