Posted by Tom Bond on February 24, 2014 at 19:14:00 from (22.214.171.124):
Switched the tires on the front and clearances were exactly the same as before switch. So I decided to try someone elses suggestion and flipped them around so they are now dish out. Now there's about 4" additional clearance on each side. Don't think it will hurt to run them like that and the weights go back on without issue. I thought maybe the wheel nuts might of been in the way but they're fine. Now the fronts are a bit wider than the rears but don't think that should bother anything or I could just flip the rears around too. Or since there wasn't really any actual problems in the first place with rubbing or anything like that, maybe I should just put them back the way they were and quit being so picky about how it looks. Any suggestions?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.