Posted by Bill Radford on July 08, 2013 at 15:47:51 from (71.65.204.159):
To all the guys that posted re hydraulic pump noise: After work I went out and pulled the pump. The good news: the cam gear is solid and straight. No appreciable wear on the gear. When I start the engine there is nothing but the normal valve train/timing gear noise More good news: the pistons underneath the wobble plate all feel good with good spring action and suction. I think that the piston end of the pump is a- ok. Bad news: When I look at the pump gear, it rotates with a wobble. The gear is supposed to turn straight but it appears that it is crooked in the housing. The wobble shaft has around 2 mm of thrust from inside to outside. I think the bearing is bad and the shaft is crooked. Think I'll replace the bearing and check the shaft and gear.May wind up replacing gear, wobble shaft and bearing. Much better than it could have been.. Thanks again Bill
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.