Posted by Errin OH on June 16, 2013 at 09:53:16 from (71.79.150.206):
I have a 100 gallon sprayer currently it is on it own wheels. I have acquired a beefy carry all that will easily hold the weight. I looked up the 3pt specs an it says it good for lifting 1200+ lbs. I figure I can use stay chains to keep the weight off the hydraulics when in use so the bouncing weight issue on the 3 pt is not really an issue. The tank, by my measurements should be about a foot behind the rear wheels and near as I can figure leaves the bout half the trans, engine, and front axel to offset the load. I have about 200lbs in weights I can add to the front if I make a bracket.
Anyone use a 3pt sprayer this size on an 800 / early 4000’s series tractor? I figure between a full sprayer and mounting I am in the 1100lb range.
I have carried 4-500 lbs on a boom pole 3' behined the wheels with no issues.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.