Sorry. I didn't have more time to respond to your last post. It sounds like your 4000 has the gear pump in the center housing. There should be a pressure port in the face of the pump. You can connect a test line to this pressure tap. Unfortunately you're going to need more than just a pressure gauge. You need a high pressure line to tap the pump. On the other side of the high pressure line you install a Tee and pressure gauge. You then exit the Tee with another high pressure line and run it to a high pressure valve. This is called a load valve and it enables you to restrict the flow of high pressure oil through your test line which places a load on the pump and registers pressure on the gauge. You run a low pressure line out the other side of the load valve back to the fill plug in the center housing so the oil circulates out of the pump and back into the hydraulic system.
This post was edited by Check Break at 21:29:37 05/27/13 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.