Posted by fatbob50 on May 27, 2013 at 13:49:14 from (67.142.175.22):
I posted this question on Implement Alley and am not sure if perhaps I should have posted it here. I need help to remove a pin. Please see photos to come. There is an arm that was broken off on the knotters years ago. They took it off and welded it, then put it back on. Needless to say it never knotted again. I am trying to fix it as I want to square bale a few acres for my horses.
When I went to take the arm off, the 5/16 bolt broke off. The bolt has a flat head on it, and goes all the way through. The bolt will not come out without removing the part in the photo. The pin in the photo is loose and you can turn it by hand. But it will not come out by tapping or beating on it. You have to take this pin out to replace the cam. I do not want to damage anything, so I was looking for advice on how to get it out. If you look at the diagram, you can see that the 5/16 bolt does not even appear on it. Thanks, Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that ‘quick look over’ before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.