Posted by WayneIA on April 01, 2013 at 11:29:13 from (207.177.85.211):
Back in the late 50s and early 60s Ford had three remote valves to fit 100'a series tractors. I know I am old and senile but I sure I am correct since I worked at a dealer from 1957 - 1964. And to further solidafy my beleif, I started farming in 1964 with a 960 and a 860 and have had all three of them. A non detended single spool, a non detented double spool valve ,and the one in most parts book which is a dented single valve. There was also a lever operated valve that could be put on the single spool detented valve to make it function like a double dented valve. Had it also. .Now my questions. Where in any Ford book do you find any thing but the single spool detented valves or the selector? Also I would like to get some banjo type fittings that would except a 3/8s hyd hose along with the hollow bolt that fit the banjo fitting. These fittings were used on all of the above valves. Sorry for the long post, just hope some one understns this!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.