Posted by Ultradog MN on March 23, 2013 at 15:11:57 from (174.20.239.40):
In Reply to: Ford 4600 timing posted by Micky Kilpatrick on March 23, 2013 at 14:57:25:
You need to give us a little more info. Usually you do not need to remove the whole timing cover to replace the pump, just the little cover in front of the gear. The pump drive gear is held captive and can not skip out of time. Did you remove the whole timing cover? If you messed with the gears it is very important that you get it timed right as the valves/pistons are interference meaning you can hammer your valves if the cam is not timed right. See the photo below for the correct timing on that engine. Also you state that now the engine will not crank. I assume the starter is working correctly and the engine cranks but will not start? Answer those questions and someone here can help you better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.