Posted by Micky Kilpatrick on March 24, 2013 at 13:04:35 from (57.80.144.6):
In Reply to: Re: Ford 4600 timing posted by Ultradog mn on March 24, 2013 at 06:32:57:
thanks on that, is it possible (i got it as a used tractor), that someone has done some engine work, and did not put the camshaft drive gear back in the correct oreintation? The reason why i ask, i can not get any of the three timing dots on the camshaft drive gear to line up with the either the Camshaft gear's one dot, or the crankshaft gears one dot. But there is a tool mark, like a punch was used, on the camshaft drive gear, and if i use that to align to the crankshaft, i also get the camshaft gear's dot at the 9'oclock posistion as shown in your picture.
Right now i think i will pull the valve cover off the top and see if i can make that #1 is at top.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.