Posted by Turnaround on January 22, 2013 at 11:25:38 from (71.54.61.193):
I have a nearly new condition, OHV Ford 172" Industrial engine that I want to install into my 51 8N, I bought a 1954 Ford tractor engine plate thinking it might work but, while similar, no go. I think the 172 was factory in the Ford 601 series machines?? Anyone know of a easy way to install the later OHV 172" engine into the 8Ns using the standard 8N transmission. I am not plowing with it, just pulling a manure spreader and working a hay spear. The adapter would have to fit against the 172's 1/4" engine plate (because of the starter mount being on the plate) and be about 1 3/4" front to rear, and then have the 8N transmission pattern. I could weld something up, but getting something that large machined flat and parallel, and drilled concentrically, is a bit of a problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.