Posted by charlie LCDR on January 18, 2013 at 15:52:59 from (68.23.152.87):
I have the style of govenor that has the two rollers. I am having problems with the govenor holding a load going down hill and I have to manually open the throttle going uphill. I have adjusted to the book and it didn't help. Springs and all look good. I have the front housing off and removed the govenor. Question 1, does the govenor free-wheel on the crank shaft or is something suppose to rotate it. I noticed the washer behind the front pully bolt is slightly concaved. Question 2, Could it be stopping the flyweights from moving all the way forward? Question 3, How thick is that washer suppose to be? When the bolt was removed I noticed the bolt wasn't very tight. Any help is greatly appreciated. This has been a good tractor but whould like to get the govenor figured out while I have it apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
