Posted by RodInNS on January 07, 2013 at 19:07:21 from (216.118.158.123):
In Reply to: 4600 - two questions posted by Ultradog MN on January 07, 2013 at 13:04:00:
Level plug should be in the housing, on the right side, about the level of the footboard or slightly above... to the rear.
The brake boot... strip the linkage off the rod, then use a sharp cold chisel to free the metal backer of the boot from the axle housing. When installing the new one I usually remove the spring, slide it all the way up the rod until it seats, then use a piece of pipe or some such drift over the rod to get the backer seated into the housing. Then you reinstall the spring. You can either drain some oil off before you start this job or run that side up on a couple of blocks to chase the oil to the other side...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.