Posted by Van D. on September 30, 2012 at 21:09:49 from (184.108.40.206):
Ok guys and gals. I've got:
1- Ford 2000 diesel tractor (8 speed trans) - loads of hours, no power steering, non locking differential, bad steering sector, worn hydraulic pump. 1- Ford 2600 gas tractor (6 speed trans) with power steering, locking differential, has low hours ~1000 hours - has a bad clutch, seized engine.
I want to make one complete tractor.
Does anyone know where i could translate/decode the transmission, rear axle, hyd. pump, & lift numbers located under the hood?
If it were to have the same ratio in the rear axle, i would like to swap the diesel engine and 8 speed trans from the 2000 onto the 2600 axles.
The rear axle codes are different from one another, but there is a large gap in date of manufacture and one axle is of locking type.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.