Posted by Kurt-NEPA on March 12, 2012 at 13:58:23 from (70.44.245.96):
In Reply to: Ford 600 hydraulics posted by BobW on February 29, 2012 at 10:32:52:
So you are back to square one Bob. I've been there several times, fun isn't it. At least you know whats new and have gained a lot of knowledge. I pulled my top cover 4 times before I got everything right. Lots of work, but it was worth it.
So, you have flow at the test port on the 3X5 plate under the seat. That's good, but do you have pressure. Plumb a gauge into the test port and give it try. If you have pressure, I'm thinking a stuck unloader valve or bad linkage. The gauge should tell. No pressure we are back to chasing major leaks or pump prime.
Your comment about the o-rings between the top cover and center housing concerns me. Those two o-rings should be in the kit. How deep was the recess they fit in. Should only be about 1/16" deep? If its deeper something is wrong. A leak there could be your problem. If you pull your PTO Lever/Cover, run the tractor, you might be able to look in and see the leak. A good mirror and flashlight helps.
Hang in there you'll get it. Keep us posted, we are all learning as we go.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.