Posted by Mark K on February 15, 2012 at 20:56:19 from (143.120.99.10):
In Reply to: Re: And more.... posted by Roger Martin on February 15, 2012 at 20:29:34:
It could go in place of it, but it would need to be wired differently. Your D5NN10300D is an externally regulated alternator, the one you are replacing it with is an internally regulated unit, so if you are going to use it, you will have to do some wiring.
You could use your B+ wire from the starter as is, but your old "field wire" and "regulator wire" from the regulator will not and will need to be covered, then you will need an idiot light wire for the W terminal, and as for the "sense" wire, I'm not sure if it will run right without it. You are going to end up with a mess unless you do a complete conversion and get rid of the old regulator.
Are you sure you want to go this way? I think I would stick with the factory setup, if not for me for the next guy! :~)
Here is your stock alternator from the second number you gave me, externally regulated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.