Posted by RodInNS on September 29, 2009 at 07:29:09 from (216.118.158.123):
In Reply to: pto posted by 1 poor ms farmer on September 28, 2009 at 15:09:36:
Until you tap the low pressure hydraulic system that controls the PTO and Dual Power (if equipped) and get a pressure reading, you are only wasting your time. It needs to make 160-180 psi with warm oil at a fast idle. I'm not sure if that tractor has a tap on the pump if it doesn't have dual power... so you may end up pulling the pump or lift cover to get a test point, or drill the manifold on the pump and tap a 1/8" NPT into it.
Beyond that, you can pull the lift cover and divert the main pump flow back down to the sump, then start the tractor and LOOK for leaks. Sometimes there's just no easy way to do this. It's nasty and dirty. Best suggestion I can make... just observe how it works. If you can tap a gauge into it externally, that will tell you a lot by the pressure readings...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
