Posted by RodInNS on September 07, 2007 at 09:14:38 from (24.224.246.156):
In Reply to: PTO Overrun Clutch posted by Brian in MA on September 07, 2007 at 04:53:50:
The mower doesn't need an ORC. If it did they would have installed it in the shaft on the mower, or they should have. If you wish to have one on the tedder I would just install one on the tedder. Most tedders have a metric WalterSchied teardrop shaft. Measure the cross size and figure out the shaft size and then order a ORC that attaches to the tractor spline on one end and that cross on the other, and also install a new cross while you're at it. Then leave the Ford to go with no ORC since you probably don't need it for most other things anyway.
Also, for those that mentioned it, there is no ORC built into the Ford's internal parts. IT is one solid driveline from the engine back, through an independant hydraulic clutch with a brake to hold it while it's not in use...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.