Posted by John(UK) on September 06, 2012 at 06:40:32 from (79.76.243.184):
In Reply to: Re: '55 TO35 Lift Cyl. posted by fltlndr on September 06, 2012 at 04:43:30:
You can replace the 2-1/2" Cylinder with a 3" type. You will need the four studs and nuts etc as they are bigger and stronger on the 3" cylinder. They went from 7/16" to stepped 1/2" studs one end and 7/16" on the other. You will also need to re-set the hydraulic controls, you can't just add the cylinder and hope for the best. Of course you will need the bigger Piston as well with the Steel Rings. These settings will most likely need to be re-set anyway due to wear and tear over the years. I have the re-setting info if you need it. John(UK)...fergusontractors@hotmail.com
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.