I went to Norms this morning too get my starter and check the bendix spring. The spring was ok and while I was talking to Norn I asked him what the start was 6 or 12 volt, he answered 6, so I asked hin change it to 12. I think this is my problem ad under the circumstances so does Norm. The timing is good, it starts immediately and I never have to use ether . so we will see. You can bet i am going to keep an eye on it. The starter rebuild with new Armature . 12 volt fields new drive labor $350.00 . I know I can get a new one cheaper but Norm started on it and ordered parts and I couldn't back out. Just part of the fun of owning an old Ferguson Tractor, I guess. Thanks guys for all you comments and help. I put Protronics in Fergie and replaced the Points , that is why it starts fast no kick back. I am going to get a new crank for it though.
This post was edited by abrahamseven at 16:08:30 12/16/13.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.