Hey Tony, seeing that picture reminds me of a question I had for you about your ATV jack.
After having to improvise a lifting/holding system so I could free up my floor jack and a couple of jack stands yesterday and change the oil in my truck, I got thinking about that a lot more. What do you use? I see a few different types on the internet, some as cheap as $100.
On another note, I finally got the lower (PTO) shaft out of my tractor yesterday so I could remove the input shaft assembly to replace the seals. That was a project all to itself and putting it back together should be, ummm interesting. Had to make one puller for the PTO shaft cover (more redneck engineering). Maybe I'll start a thread about that and put up some pictures 'cause they sure would have helped me. With only having the I&T manual I really had to read between the lines. All the info is there you just have to read and re-read to get what you want from it. The seals I ordered showed up and my level of enthusiasm is slightly higher than it was a month ago so who knows, I might be putting it back together soon.
This post was edited by Inno at 05:52:58 05/05/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.