It will cause more damage than just oil seals leaking...I done some looking and here are John(UK) words on it....
You can get the shims from a Sparex dealer as part S42622 these are .010" The MF part number is 181-232M1, you can also get some from later models that will fit. 35/135"s and any tractor types with same drum brakes, these shims will fit but they will have 12 holes instead of the 6 holes for the grey tractors. Do Not use paper gaskets as a substitute and do not use any sealant or the Hub will move on the axle and it will leak again. Paper gaskets should be fitted one each side of the brake back plate and the shims go next to the Rear axle housing. It is important that there are sufficient shims or the bearings will be overloaded when you tighten the Hubs to the tractor.Too many and it will knock as the bearings will be too loose and in severe cases it could knock the collars off the shaft..John fergusontractors@tiscali.co.uk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.