Nearly all Ferguson implements attach to the Top Link connection, only a few special implements use the lower hinged pin. A Post Hole Borer is one, the Trailer Hitch is another and draw-bar stays for the linkage draw-bar, but there are a lot more. It is just a stronger attachment point and was used on the old Grey tractors right from the very early days. You can safely use the Top Link connection to attach your Ferguson Mower without any problems as it is made to attach at this point. Regarding Draft Control, obviously you don't use it as it is not running in the ground, so you use Position Control if you have a 35 type tractor, which will hold the mower at whatever height you need to set it above the Ground and you move the Draft Lever down to the bottom of the Quadrant out of the way. If you have a 20 or 30 type tractor, then you use the Chain in the center of the mower draw-bar, hooked into the Rack on the Top Link to hold it at the correct height (PTO shaft Level) and lift and lower with the Quadrant Lever as normal....... John(UK)...fergusontractors@hotmail.com
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.