Posted by PackardV8 on October 30, 2012 at 19:26:38 from (205.188.116.19):
In Reply to: Timing sight hole posted by HillsOfTN on October 30, 2012 at 04:27:26:
Quote:
"100% To20 except for the replaced block and, therefore, does not have the timing marks on the pully and timing cover"
My To20 has the timing COVER marks. Looks like two cast-in triangles. It also has the hole in block under starter and the flywheel marks. I have never checked to see if the pulley is notched or not. I've always timed this TO20 with a lite or static thru the hole.
My TE20 has the timing COVER marks (like two cast-in triangles) but has a front pulley with NO notch. Also odd about the front pulley is that it has 4 holes for a puller tool. A very large flat headed screw instead of a bolt holding it onto the crank shaft. THe large screw is slotted for a standard blade type screw driver. NO ratchet for a hand crank,. The hole thru the front axle pivot does not line up with the center of the engine crank shaft. I've not tried setting th e timing on the TE20 yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
