Posted by PackardV8 on October 29, 2012 at 17:32:29 from (205.188.116.19):
In Reply to: electronic ignition posted by Al Clark on October 28, 2012 at 22:36:44:
Quote:
"Distributor cap contacts look rough, particularly
the one for #4. It also apparently moves up and
down a quarter of an inch because the wear on all
the is about that long.
the cap and rotor are fairly new. I"d say much
less than 100 hours on them"
I don't know what u mean by "contacts look rough". If that means buring or as if it was ground on with a file.
If as ground on with a file and not burned then cheque the rotor button. My recently acquired TE-20 has what appears to be a new cap and rotor. BUT the rotor contact is way too long and hitting the contacts in the cap. I filed the rotor buttom contact down about 1/8". It was way too long and i am amazed it did not break the rotor or the cap but it didn't. The shaft in my distributor is probably worn .005 or more. But it starts just fine and runs what little bit i have ran it just back and forth to garage.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.