Posted by John(UK) on September 20, 2012 at 04:36:30 from (79.76.253.110):
In Reply to: TO 35 Govenor posted by StvRkh on September 19, 2012 at 16:33:07:
The governor will never work unless the compensating spring and link is fitted. Both springs must be in good condition and not stretched or rusted or they will be weak, same applies to the one on the vertical rod, they are available. Governor will not operate correctly if there is anything wrong with the springs. This could be part of the cause of sluggish operation, but the usual error is the Bumper Spring has been adjusted incorrectly and too much pressure has been applied.I have the dimensions of the Compensating link and the information about how to adjust the Governor correctly. Because the Governor is not operating correctly, never presume that it is the Governor, it is almost always adjustment of the linkage, no matter what tractor model you have. When you took off the Timing Cover did you replace the oil seal and gasket as they often leak when they have been disturbed. If you need the setting information for the Governor and the compensating spring link, email me direct and I will send it to you....John(UK)...fergusontractors@hotmail.com
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
