Posted by mkirsch on December 22, 2014 at 12:56:28 from (72.45.143.81):
In Reply to: IH 606 Draft Control posted by IAtractorKid on December 22, 2014 at 12:38:39:
I just helped Dad work on the 3pt unit for his 656, which looks pretty much the same as that parts diagram you posted.
The problem with his was in the draft control feedback linkages, and let me tell you it is a nightmare of complex mechanisms, impossible angles, and "Jesus clips" galore.
Even with the large top cover removed we couldn't get at anything we needed to so we ended up lifting the unit off the tractor, and flipping it up so we could get at it through the small hole in the bottom.
Unfortunately I didn't pay attention to where the levers came in. Maybe you can get them after lifting the cover off under the seat. If so you'll have it fairly easy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.