Posted by IAtractorKid on June 22, 2014 at 14:20:23 from (22.214.171.124):
Ok guys so I am rebuilding the factory IH wide front on an M. This has the tie rods in the rear. Anyway, The center tube had alot of play on the pivot pin so I ordered a new pin and bushings. Once I pulled it apart, the old pin is in really good shape but the bushings are pretty worn. My problem is that the bushings look like the ID was always too big...not just worn that much.
I got the new bushing from the local auto parts supplier that has always been real good about bushings, bearings and seals. I was trying to avoid spending $86 for them from IH. I gave them #48841D part number, they crossed that to FP- A27846 (package says Piston Pin Bushing but I guess it would work). These bushings have an ID of 1.3125" and the shaft measures 1.1875" Did they cross reference the bushing wrong or did these really have that much clearance to begin with???
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.