Farmall & IHC Tractors Discussion Board |
Re: GOT A LEAK!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Garnet on November 18, 2000 at 08:15:57 from (142.177.105.180):
In Reply to: GOT A LEAK!! posted by plowboy on November 18, 2000 at 06:08:25:
Well, - it's not really easy but you don't have to completely pull the axle. First get your gasket. Should still be available from nearest Case-IH Dealer. Remove the wheel, drain the rear end, remove the PTO assembly and drawbar. Remove the bolts holding the axle housing. Reach in through the PTO hole and remove the cap screw and washer from inside end of axle. Carefully drop the Bull Gear off the axle. Now you should be able to ease the axle and housing out far enough to remove the old gasket and carefully slip the new one over the housing and into place. Might want to support the outer end. A bit of fun getting that bull gear back on but it can be pried up and have helper turn axle as required to align splines and slide whole works back into place. That rear end holds nearly 15 gallons of grease so have a couple of containers ready. Good Luck. Took the whole works off my Super M before figuring the gasket would slip over the housing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|