Farmall & IHC Tractors Discussion Board |
Re: farmall 350 sheet metal removal troubles
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny on November 09, 2000 at 10:27:03 from (12.4.181.2):
In Reply to: farmall 350 sheet metal removal troubles posted by joe on November 08, 2000 at 16:09:29:
Seems to me that 300, 350, 400 & 450's had some sort of captive square nut like a Tinnerman nut and the hoods & grills were held on with a large pan or button head phillips machine screw. The 450 Dad had used about 5/16 or 3/8" dia. by at most 3/4" long screws. Would rattle out & loosen up but you's strip the cross out trying to take them out. I think the 460/560's used something similar but different.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|