Posted by marc walker on December 24, 2012 at 08:30:31 from (184.108.40.206):
I am in need of some wiring advice. I have copied all past wiring post for Farmall A and SA but have misplaced them. What I have is a Farmall A with a c135 engine with bits and pieces of wires. 1-It is 12 volt neg ground. 2-It has a two wire on/off switch. 3-A two wire starter button. 4-A 4 flat post car resistor. 5-A solenoid with all the wires on one large post, I guess it was used as a junction point. 6-coil. 7 Battery ignition. 8-A 3 wire delco alt. with 3 wires 1 large red on back, 2 on side red/black A simple point to point diagram would be really appreciated I would like to get it running over the holidays. Thanks to anyone with time to help. Thanks again Marc
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.