Farmall & IHC Tractors Discussion Board |
Re: paint for 1466
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by S-E Michigan Part Timer on October 24, 2000 at 13:55:05 from (208.223.205.166):
In Reply to: paint for 1466 posted by MAGNUM on October 24, 2000 at 09:35:09:
Just a bit of what I picked up from a body-shop.. Never sand to bare metal unless it needs to be repaired. Only prime bare metal, not previously primed or painted surfaces (assuming there already is a good bond) So lets say there are chips in the paint, sand them smooth, prime, sand again, then paint. Just make sure what ever you plan to paint has had the "shine" taken off with 400 grit or so. The shine will let that pretty red paint flake right off.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|