Posted by Brownie 450 on February 22, 2012 at 13:33:12 from (66.43.241.198):
In Reply to: Machine Shed posted by d282 on February 22, 2012 at 13:10:22:
I've got a quonset which we put up in 1985. The price has more than doubled since then. Concrete has gone up as well. I think we put around $8000 into a 42X80 ---that was concrete & building. Thought about skimping & putting 8 inch wide footings--talked to the guys in town & they said 12 inch wide. Never regretted the extra cost--I've seen quonsets that the sides spread out from snow load. The nephews are putting up a hoop outfit, & it looks to be fairly well made. Don't know how much wind load they'll take, though. We didn't even get the ends in our shed before the assessor stopped by to measure it. He asked if we'd have it done by fall, & I said I didn't know for sure. He said to call him if we didn't get it done. They're very helpful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.