Farmall & IHC Tractors Discussion Board |
Re: F-14 Restoration
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by MikeH(Tx) on March 28, 2000 at 12:19:54 from (192.55.24.50):
In Reply to: F-14 Restoration posted by OnRon on March 28, 2000 at 09:49:08:
Yes, you can find just about anything you need for an F12 or F14. The most complete list of parts I have found has been at Rice Equipment. Give them a call, or send a S.A.S.E. for a parts list. The link below will give you their phone number. Ask for Gordon. Wheels from an H and C have 2.5in axle holes while the F14 and F12 have 2.625in axle holes. (I don't know M's at all). They can and have been made to fit, but it is tight. Also, the H used 38in wheels and the C used 36in while the F12/14 used 40in (generally for all. Many exceptions). Substituting smaller diameter will make the tractor tilt one or two inches to the rear. Not objectionable, but keep it in mind. Also available out there are cutoffs - F14 40in rims and hubs that were cut apart and the hubs welded to 38in rims. These are what I have on my F12.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|