Farmall & IHC Tractors Discussion Board |
Re: 424 PTO problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bernard le mécano on July 29, 2007 at 08:53:23 from (207.134.205.166):
In Reply to: 424 PTO problem posted by Bobinvt on July 28, 2007 at 19:08:29:
Hi Bob, it have a bushing where the dog engage. The bushing aling the two PTO shafts, when the bushing is worn the dog don't stay engaged.To change the bushing, drain all the transmission oil, remove the PTO lever, the rear PTO shaft, by the cover to access the clutch, remove the large snap-ring, the cap then the snap-ring on the PTO shaft, remove the next cover, push the PTO shaft then remove the snap-ring next to the gear. Push the shaft all the way to the rear hole. Change the bushing and check for wear on the shaft, machined if so . Bernard le mécano Québec Canada
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|