Farmall & IHC Tractors Discussion Board |
super a rebuild 2 questions.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by werowance on January 22, 2007 at 16:28:15 from (216.24.109.237):
im rebuilding a super a (im sure alot of you already know as i have asked sever questions, but please bear with me.) i have 2 questions 1. i am looking for the front crank pulley seal. the one with a wear ring that goes on the pulley to repair the worn in groove. my ih dealer says they only list the seal without a ring. does anyone have the part number for the one with the wear ring, and where to buy it? 2. im replacing the 2 freeze plugs on the back of the block with new ones. they are nothing like the brass ones im used to with chevys and such. they are bowl shaped. which way does the highest point in the middle of the bowl point, in the block or out of the block. hope this diagram goes through. outside = ) or outside = ( () is supposed to = how its supposed to be.
and how do you recomend installing it? i often use the yellow trim adhesave on chevy freeze plugs, but what about these? thanks for any and all help Bryan
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|