Farmall & IHC Tractors Discussion Board |
gear box problem on a finishing mower
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Charlie M on July 23, 2006 at 11:14:46 from (65.37.82.45):
I've got a 5ft mower I use behind my IH234 that had the gear box go bad a few years ago. It totally stripped the teeth on the gear from the PTO but the teeth on the gear going down to the blades appears OK. I bought a new top gear, bearings and seals and reused the bottom gear. Now the gear box chatters really bad making me think I should have replaced the bottom one also. I still don't see any bad teeth on the bottom gear. Is it possible the two gears don't mesh tight enough or is there something else happening. It also leaks oil badly from the bottom gear seal but its possible I just messed it up putting it together.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|