Farmall & IHC Tractors Discussion Board |
b block swap
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by scotc on June 23, 2006 at 15:05:16 from (12.145.221.66):
I"ve been thinking about what all I am going to do with the B when I get around to fixing it up and am thinking I would like hydraulics. I"ve heard that some of them came with an A block and the live pump could be mounted to the motor and a system set up. If I switch to another block I was thinking I may as well step up in displacement too. Would a super A or C, 100 or 200, 130 or 230 motor fit in a b and allow me to put the hydraulic pump on it? Or would the steering shaft get in the way? The cost on top of the powder coating and pearl coat paint may kill this idea though.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|