Farmall & IHC Tractors Discussion Board |
Re: gear shifter farmall 300
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on January 15, 2006 at 07:27:51 from (209.226.247.147):
In Reply to: Re: gear shifter farmall 300 posted by Dick Davis on January 15, 2006 at 06:21:55:
Dick: I agree with you whole heartedly, however it is close to 20 years since I did the last one, thus I just don't remember the exact measurment. I will give you a guess, just to see how close I come when someone does post the exact figure. My guess is 5/16" by 9/16". The only ones I have ever rebuilt are H, 300 probably 3 times, 560 and a couple of offsets. I'm thinking all H, M, 300, 400, 460, 560, etc. are the same. Offsets and C through 240 may be slightly smaller. I never did record the size of shift lever at the time, but rather went to size of notch in the shift rail of each tractor. I just don't know if they are all the same, not even positive of the ones, that I suggested might be the same.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|