Farmall & IHC Tractors Discussion Board |
Re: Wits End - Leaking Oil
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on October 25, 2005 at 17:41:07 from (24.235.41.226):
In Reply to: Wits End - Leaking Oil posted by Farmall Frank on October 25, 2005 at 15:07:23:
Frank, do exactly what Scott told you. I do have a story though, I was working on my 350 Camero and I had an oil leak around the pan. I removed, cleaned and siliconed the pan, new gasket and same on engine side...a few days later I see the same leak, someone told me it was likely the sending unit, did that too, then someone thought it was from the back of the intake manifold, took it off and resealed with new gaskets..still oil leak ...laying under the car one night in frustration I ran my wrench over the oil pan..suddenly a bead of oil appeared, shoved a little harder with the corner of the wrench and put it through the pan! I couldn't see the pin hole before but that was the source of the leak, I felt stupid about all the work I had done trying to solve the leak and it turned out to be the pan itself....=new pan ... now I told this story for a reason , check the pan very carefully for pinhole leaks around the flange. I didn't think something full of oil would rust through.....Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|