Farmall & IHC Tractors Discussion Board |
Re: Hardner
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on October 04, 2005 at 19:43:14 from (204.249.178.138):
In Reply to: Re: Hardner posted by sammy the RED on October 04, 2005 at 17:50:15:
I use "bondo" as a generic term even though it is a trademark. Evercoat is good stuff, although the local dealer doesn't carry many versions of it. I generally use PPG's body filler, and sometimes put Evercoat's Metal Glaze over it. Either one leaves far fewer pinholes than the trademarked Bondo. I would like to try Evercoat's Metal-2-Metal, the aluminum reinforced stuff if I could find it. I use a lot of JB Weld as a first application, if I have dents deeper than about 1/16-1/8 inch, then cover it with body filler. I don't believe the JB Weld will crack or fall out like "bondo" will if it gets too thick -- at least it hasn't yet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|