Farmall & IHC Tractors Discussion Board |
Re: IH 240 Utility clutch problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JerryW on August 11, 2005 at 10:52:49 from (208.204.140.30):
In Reply to: Re: IH 240 Utility clutch problem posted by Dave D on September 18, 2004 at 16:58:32:
I think I might have the same problem on my IH 240U. I can shift ok if I don't hesitate when I shift...but if I take it out of gear and let the tractor sit for a minute I can't get it back in gear and it grinds quite a bit. My work-around is I shut the tractor off, press the clutch pedal and put it in gear with tractor off. I can feel something happen inside gear housing that clicks the shifters back into the right position. Then I take it out of gear and re-start and I'm able to get it into gear again ok. If you solved this problem let me know. It's probably easy but I'm just starting the refurb work so I haven't gone over everything yet. One thing I just realized from another post is I'm probably low on Hytran in the tranny, I only put in about 6 gal but I recently read that I'm supposed to have closer to 12 gal!! So that could be part of the problem. jerry from CT
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|