Farmall & IHC Tractors Discussion Board |
Re: Farmall B governor {not workin as it should}
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by aug on April 24, 2005 at 08:47:37 from (205.216.79.172):
In Reply to: Farmall B governor {not workin as it should} posted by fred {mud} hudson on April 24, 2005 at 05:17:13:
Mud,--I had the same problem on my B. LACK OF LUBRICATION. The way I fixed mine was to run a little oil line from the the oil gallery up to the top of the gov housing where I drilled & tapped a hole directly above the gov mecanism so that engine oil would drip on the gov shaft.After I had it all hooked up,I pinched the oil line with a vice grip so that oil would would just DRIP.--- There may be easier ways to do this,like drilling a hole in the top of the housing and oiling it with an oilcan. Up to you,but you will see when you take it apart that that particular area of the the engine is not a well oiled spot. Best to you---Bill
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|