Farmall & IHC Tractors Discussion Board |
400 split done ( well sort of)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on November 30, 2003 at 19:55:00 from (63.171.43.140):
A few people on the forums suggested that I block the front of the tractor and rig it so that you pull the rear away. Of course I decided not to do it that way. I figured I would block the rear and pull the front away from it. I would have to say that after this. The forum suggestions were correct. If it were not for a suggestion from Nebraska Cowman to use some all thread. This would have been a disaster. I used a cheery picker hooked to the frame rails to support the front and allow me to move it. This did work as you can see, but the front wants to pivot on the chain. I am not sure how to explain it but the wheels moved forward changing the angle. Luckily I have the threaded rod on there to keep it lined up. Needless to say this is as far as I am going to split it this time. There is just enough room for me to get at the clutch and replace it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|