Farmall & IHC Tractors Discussion Board |
Re: c clutch won't release
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in Ne on April 23, 2003 at 04:11:40 from (216.58.237.20):
In Reply to: c clutch won't release posted by picasso on April 22, 2003 at 18:59:50:
A little safer thing to try than what Bill B just said is to leave it shut off. Put it in gear. Have somebody step the clutch and then try rocking if back and forth. If that doesn't work then I would try towing it. Leave the engine off. Put in gear, step the clutch and start pulling the tractor slowly. You may have to start and stop several times in this method of rocking it. If the clutch plate is just rusted to the flywheel I would think that this should break it loose. My 12v C would start in gear but I don't think that my 6v C would. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|