Farmall & IHC Tractors Discussion Board |
Re: IH 240 Tractor - Rebuild or not?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ed on November 04, 2002 at 21:09:48 from (152.163.189.203):
In Reply to: IH 240 Tractor - Rebuild or not? posted by Joe Herold on November 03, 2002 at 17:17:11:
Something to keep in mind as far as oil pressure goes on that engine is there are no cam bearings, the cam just rides in the block. The bores on my 240 are a little loose so even with new crank bearings and a good oil pump the pressure is kinda low when it warms up. I don't use the tractor in the real cold weather so I put 20w-50 in it and it will hold about 20# when hot.Good luck, Ed
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|