Farmall & IHC Tractors Discussion Board |
Re: Stuck engine on an M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on October 22, 2002 at 18:01:57 from (12.40.186.111):
In Reply to: Stuck engine on an M posted by Larry on October 22, 2002 at 17:26:57:
On my 2 H's with stuck engines I removed the engines and then set to work with the hammer. Much easier when the engine is up on the stand. Doing the same now with a 450 engine. I've been lucky enough that once I get the engines out of the tractors and set upside down I can remove all the main caps, flip the crank over and remove all the rod caps too. Then I can get the crankshaft out of the way and not worry about damaging it. Good luck and take the engine out, it's easier that way.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|