Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 3 point for a C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill on June 28, 2002 at 04:38:43 from (63.89.120.133):
In Reply to: Re: Re: 3 point for a C posted by Steve Mason on June 27, 2002 at 06:13:46:
Steve, I don't have a camera so can't post pictures- I'll ask around to see if I can borrow one. In the meantime, it is a category 1. To get started I went around looking at a variety of 3 point setups at a local dealer of used tractors. I took measurements and also used the 3-point specs from the R&I information on the left of your screen. I found a rear cultivator setup at the junk yard. The only real machining I had to do was slightly enlarge the holes in the drawbar bracket (to 7/8") to mount the control arms, and weld a bracket to the cultivator assembly to attach the top-mount. I kept the original drawbar with no modifications. I hope this explains it enough to get started. you can e-mail me if you have more questions. I will try to get a hold of a digital camera.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|