Farmall & IHC Tractors Discussion Board |
Re: Super M Gear shift
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on June 06, 2002 at 05:30:17 from (12.74.160.251):
In Reply to: Super M Gear shift posted by BEL@IN on June 05, 2002 at 17:07:12:
First, there is a soft plug on each side of the cross shaft. You have to get at least one of the plugs out first. They are bigger than the shaft and sit in a recess. A small sharp cold chisel can be used to dig them out. Then the shift lever is spring loaded up. The cross shaft is probably worn with grooves in it. Push down on the shift lever while working the shaft with needle nose pliers and you will probably find it will come right out. It will take some jockeying around to find the right amount to push down to get the shaft free.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|