Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall 400 Brakes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on April 25, 2002 at 09:17:32 from (165.170.128.65):
In Reply to: Re: Re: Farmall 400 Brakes posted by scotty on April 25, 2002 at 07:52:43:
Scotty - Those brakes are easily serviced "in the field". Only tools needed are a 7/8"(?) socket + rachet to remove the cover bolts and a 3/4"(?) open end wrench to loosen the pull rod lock nuts. Some mineral spirits or couple spray cans of brake parts cleaner, an old paint brush, some clean rags and a couple sheets of coarse sandpaper (to remove the inevitable glaze from the iron braking surfaces) will be helpful too. Be careful not to drop the covers when you pull them off - they're heavier than they look and can make your toes HURT!
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|