Farmall & IHC Tractors Discussion Board |
Re: Re: Timing an H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick Davis on February 04, 2002 at 17:31:11 from (205.188.195.21):
In Reply to: Re: Timing an H posted by Bob - w/link to photo that might help on February 03, 2002 at 08:45:37:
Bob, Thanks You have been a great deal of help so far! The camshaft gear marks were there all along but were so unprofessionally done I thought they were casting flaws! Your explaination of there being two set of marks 180 out made the difference, thanks. But.. the only mark I find on the crankshaft is one that lines with the keyway and they both are at 12 o'clock when the # 1 cylinder is at TDC. So, this mark can't line up with the cam shaft mark. There must be a number of teeth counter clock wise from TDC to line up with the cam marks. Sorry this is so involved but I can't explain it completely in fewer words. Thanks Dick
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|